Working from Home – Assembly
Lenovo ThinkStation P300 Series

Step 1: Placement

Setup the monitor(s) and computer. Place the monitor and computer on a desk or work area. Be sure to place your computer case in an area that is well ventilated and has good air flow. This will help to prevent the computer from overheating.

Step 2: Surge Protection

Plug the surge protector into a wall outlet. You may also need to turn on the surge protector if it has a power switch.

Step 3: Monitor Cable

If the monitor cable was removed, locate it and connect it to the back of the monitor. Finger tighten the screws, if applicable. Repeat if using two monitors.

Cable Monitor

Step 4: Monitor to PC

Connect the other end of the monitor cable to the back of the computer. Repeat if using two monitors.

The ends of the monitor cable will only fit a specific way. If the cable doesn't fit, don't force it or you might damage the connectors; flip the plug end over instead. Make sure the plug aligns with the port, then connect it.

Step 5: Monitor Power

Use the power cable to connect the monitor to the surge protector. Repeat if using two monitors.

Monitor

Step 6: Computer Power

Use the computer power supply cable to connect the computer to the surge protector.

Step 7: Keyboard and Mouse

Connect the keyboard and mouse into one of the USB ports on the back of the computer. These will also only fit a specific way. If the cable doesn't fit, flip the plug end over. Make sure the plug aligns with the port, then connect it.

Step 8: Wacom Tablet

Connect the Wacom Tablet to the USB port and DVI port on the back of the pc. If you are using an adapter, the Wacom Tablet may be connected using the DisplayPort or Mini DisplayPort instead of the DVI Port. Connect the Wacom Tablet to the Surge Protector as well.

DVI

DisplayPort

Step 9: Network

Determine if using a wired or wireless connection to the internet equipment (wired is recommended whenever possible.)

If using wired, connect cable from the computer to the ISP modem/router

If using wireless, connect the wireless adapter to a USB port on the back of your computer.

Step 10: Headset

Connect the headset (built-in mic) into the front headphone jack of the computer.

Step 11: Boot

Press the power button on the monitor(s) and computer, and Wacom Tablet. If the lights do not come on, ensure that the surge protector is switched on.

Completed and verified all the instructions, but still need help with assembly?

Call 563-875-2000 and enter extension 6666 for assistance.

*** Please email ushelpdesk@tomy.com for all non-assembly issues.